Wednesday, 8 February 2017

headlight renovation every car do it yourself, foggy headlight fixing, dirty headlight, car lamp foggy, Renault scenic 2, restoring lamps, restoring lights

This time quick, easy and cheap way to make your lamps looking like new:

What would you need:
Sanding paper (waterproof) grades/grits in order: 1500, 2000, 3000, 5000 and polish paste/wax etc, or even whitening tooth paste.

I mentioned few grades of paper, you may skip some of them however I cannot predict the effect.

I tried to be smart and use sanding discs to safe time and work, but after 2 minutes I learned that's not the way, as I could not keep the even pressure all over the light. However the discs used by hands did the job ;)

Before we start just a quick comparison before and after:








First thing you have to perform is to clean your lamps properly. I used "Te...o" branded window spray. It did the job. When you start to polish lamps remember about changing water at least once with every grade of sanding paper.


Secure the chassis

Starting with 1500

Then 2000







3000




  And finally 5000


For final polishing I used Turtle Wax, it was actually the cheapest :), you don't need special polishing agent for headlights, cheapest it the best or whitening toothpaste

Hard sponge for polishing

That is how the light looks like before final polishing, a bit foggy



and soft hairy disc for the final job



Total cost approximately: 1-2eu per disc, you can polish it using bath sponge, turtle wax 4eu so 10-15euro max
Thanks


Dashboard dual camera installing, vehicle camera, car black box in Renault Megane and any other car, step by step, cigarette lighter on off switch regardless of the ignition,, radio code entering, reversing camera

Hi all

Welcome to 2017:)

I hope you had a great fun on New Year's party.
Today I will show you step by step how to install dual car camera, with reversing camera option.

Few things you should consider before buying camera.

There are few types of them,
- typical dashboard camera with suction mount, you just put it on the windscreen, plug in and that is it
- mirror camera, that is mounted on top of existing mirror
- both of the above with second camera on the rear
- double camera - 2 cameras fitted in 1 device with rotating heads - very expensive option.

I chose the mirror camera. It is fitted to the car and stays there all the time, it is not visible form outside (unless you know it is there), and has 170 degree angle, which is as far as I know the widest angle available now.
I don't have extras like gps tracking, high quality pictures etc.
It is HD, wide angle, mirror type (don't have to be removed every time I leave the car), and it is pretty cheap around 25-30euro. In addition it has motion sensor, so I am quite happy. It is my second one. First is fitted in Scenic.

IMPORTANT:
1. In this instruction you will take power from a wire powering the radio. So you have to keep in mind that by switching on the power in cigarette lighter your radio is powered so always switch it of before using an extra circuit. Do not use cigarette lighter to warm up cigarette lighter unless ignition is on.
Just in case I used security device - 2AMP fuse, which is weak enough to stop any strong power consumption on a extra circuit.
2. You will need to reset your radio, do you have radio code???

Let's get started.

Megane is 2004 so it is MK2


Central console has to be removed first. It is not so difficult, but take some care to avoid damaging the pins/hooks




 No special tool needed to remove radio


 Pin in on 1 side, slightly pull out and then do the same on the other one










 Bolts Torx screwdriver needed







 Just by the way I changed dash bulbs





 Because camera has battery between 300-500 mAh it can run for max 1 hr. What if you are going shopping, or to gym for few hours, or just left car in unknow area? That's why I put independent power source to cigarette lighter.


Every radio has independent power cable, we have to find it.

 To be 100%  sure we have "-" I connected wire to the minus on the battery...

 ... and found powered wire. I checked cable by cable




Smart clips helped a lot


So I have "plus". I took the "minus" from chassis. 


Having all of this I need to put wire into cigarette lighter. First remove the plastic console, carefully as the cigarette lighter cables are very short.

As before using meter or simply cables and a bulb you have to find which wire is the power one (ignition has to be on).





Switch with a led. Whenever led is on - cigarette lighter has power on





Drilled hole






This security fuse has to be somewhere between positive and negative connectors







Put everything back as it was before





Radio code has to be input using buttons on a radio as long as you will have your code on a display
 To enter it push the button on a driving wheel remote as on a pict



Time to fit camera



Takes a while, and you have to be patient ;). Wire should go either on the floor or under upholstery. This is my option. So you'll have to lift every piece of it and put the cable under it.

















Wire is a bit to short to connect it to the light. This one is activating reversing camera once you engage the "R" gear in your car







Althoug camera the rear camera works fine if only positive wire is connected to the light, however the second wire is there for a reason, so I connected both of them, 1 to light, the 2nd to the chassis.

 Orange bulb is probably as old as my car, had to be replaced







 Finally


When reversing gear is engaged

So how does it work?

When you will get to your car switch the ignition camera starts automatically as it detected power from cigarette lighter, led is on on the switch.
When you stop your car, turn off the ignition, camera switches off, and the led is off too. If you switch the button on, led is on so is camera. If by mistake you will switch cigarette lighter on, the security fuse will blow and nothing else will happen.

questions suggestions comments - feel free

Thanks

Wojtek